The border came and the finished size of your panel

Diafane can place the border came inside the drawing so that the stained glass comes out at the size you drew. A came left centered on the line adds one came width to the size.

  1. Spot the size difference a centered came causes By default, Diafane places a came centered on the path: half of the came on each side of the line. Between two pieces, the came stays centered. On the border, the outer half of the came sticks out past the drawing. On each edge, the assembled panel therefore extends past the path by half a came width: it measures one came width more than the path, in width and in height. Select the border: the W and H fields of the Transform section, in the right panel, give its size including the came. A centered came makes them exceed the size of the path by one came width. But there is a solution!
  2. Find the Position row for the came With the Selection tool (V), click the border path or paths. In the right panel, find the Position row of the Lead section. This row offers three buttons: Left of the path, Centered on the path and Right of the path. On each button, the gold line is your path and the gray rectangle the came.
  3. Place the came inside the drawing Choose the button that puts the came inside the drawing. The path does not move: only the came changes side, and the screen shows it at once. The outer edge of the came sits on the line, and the stained glass comes out at the size you drew. The W and H fields then give the size of the path. If the border is made of several paths end to end, such as an arch and its two uprights, select them together with a single click of the Selection tool. The button then places the came on the same side for every piece.
  4. Choose the U profile on the border On the border, the U profile takes glass on one side only. In the Type row, select U profile. The help button on that row shows the difference from the H profile.
  5. Check whether Diafane already set the came A path drawn right on the edge of the cartoon does not need this setting. As you draw it, Diafane tries to guess your intention and places the came inward by itself (if you draw a rectangle, an ellipse, a polygon, a line or a path with the Pen). A border drawn inside the edge, with a margin, keeps its came centered: set its position by hand.

In Tiffany, the Position row sets the solder line in the same way. The Type row does not exist in that case.

On a flat Tiffany panel, the frame around the edge is chosen in the Project settings, Technical tab, under Panel border: None, U lead came or Zinc channel. This frame is counted in the Measurement and pricing tab of Workshop mode, on the Border line.

Start for free, with three projects.

Sign up for free

We verify your e-mail address, nothing else.