Whether you work in lead or Tiffany, Diafane follows the technique you chose. The shape of the glass pieces, the right panel settings and the measurement adapt to it. You can change it at any time.
The window for creating a project offers the two techniques under Drawing technique.
To change it later, open the Project menu (the project name, in the top bar), then Project settings, Technical tab. The change converts the whole drawing, after confirmation: a single stained glass window cannot mix two techniques.
This tab also holds the default values of the project. For lead, they are the Width of the came and its Heart. For Tiffany, they are the Solder line width and the Spacing. They are used for the next paths. When you change them on a drawing that already exists, the Apply to the entire existing drawing checkbox extends the change to the existing paths.
The Lead block, under Transform in the right panel, holds three settings specific to this technique:
Type: the profile, H, which takes glass on both sides, or U, which takes it on one side only. Width: the overall width of the came, flanges included, the width you see on the finished stained glass. It sets the thickness of the black line on screen: that line is the came seen from the front, not the cutting line. Heart: the thickness of the central part, which slides between two pieces of glass. The glass slides under the flanges and stops against the heart, so the cutting line runs under the came, near its middle. The heart determines the gap between the pieces once cut.
The glass is therefore larger than the colored area you see. The Workshop templates already give the shape to cut.
In Tiffany, the block is called Solder and holds two settings specific to this technique:
Solder line width: the width of the solder visible on the finished stained glass. Spacing: the space left between two pieces of glass, taken up by the copper foil. This spacing plays the role of the heart of the came: it determines the gap between the pieces once cut.
In the Technical tab of the Project settings, the Panel border row offers None, U lead came or Zinc channel.
The border is not drawn on the cartoon. It is counted in the measurement, on the Border line, with its price.
In lead, the measurement counts the length of lead came, H and U separately.
In Tiffany, the measurement counts the solder by weight, the copper foil and the border.
Set the prices for both lead and Tiffany in the Preferences, Pricing tab.
The technique sets the look of the cartoon, the dimensions of the pieces and the cost estimate. The drawing itself stays the same: the same paths work for both.
In Project settings, click the other technique: Lead or Tiffany. This choice is in the General tab as well as in the Technical tab. Diafane warns you right away: your whole project will be converted. The conversion affects the whole drawing and offers no checkbox to uncheck, because a single stained glass window cannot mix two techniques.
The conversion is applied when you click Apply. Cancel restores the original technique. Once applied, Cmd + Z undoes it in a single step.
The default values come from the Preferences, Technical tab, and are copied into every new project. You then adjust them path by path, without changing the other paths.
We verify your e-mail address, nothing else.