Never lose a sheet of glass to a drawing flaw again! Once the warnings are displayed, three symbols on the cartoon point out what could get in the way of cutting.
By default, the symbols are hidden. In Cartoon and Workshop modes, the Warnings button in the left rail opens a menu. Its Show warnings switch, at the top of the menu, shows or hides all the marks without changing the drawing. Each symbol can also be turned off separately. With the switch off, the rest of the menu is grayed out.
Show the symbols when you check your drawing.
The red circle appears where two paths run close to each other without touching. Two pieces then risk turning into one.
The triangle marks a piece whose shape will need care when cutting: an angle that is too tight or a tip that is too thin.
The cross appears at the center of a piece that is too small to be cut from the glass.
Strictness, at the very bottom of the menu of the Warnings button in the left rail, affects only the circles.
Strict, the default setting, requires the came to reach the neighboring came. Tolerant accepts it when only the rounded end of the came touches the neighboring came. The triangles and the crosses do not depend on this setting.
With the Direct selection tool, click the end in question and drag it onto the neighboring path. The Lines and points snap connects it.
While you work, the marks disappear, and they come back a moment after your last gesture. Once the joint is made, the circle does not come back. Well done.
The Back view button in the left rail flips the drawing on screen, as if it were seen from the other side of the panel.
The symbols are never printed: they do not appear in a PDF, an SVG or a photo.
We verify your e-mail address, nothing else.