Create a project and set up its cartoon

The window you use to create a project can also be used to adjust it later. Its four tabs set the cartoon, the technique, the drawing and the installation address. Diafane uses them to work out the cutting outlines and the path of the sun.

Name the project

The General tab holds the Project name, the one that appears in the library.

Set the size of the cartoon

The tab also holds the dimensions of the cartoon, Width and Height, in the unit set in your preferences.

The link between the two fields locks the proportions: when it is on, changing one dimension adjusts the other proportionally. It is on in a new project, and Diafane remembers the last state you gave it for your following projects.

Choose the drawing technique

The same tab holds the choice of the Drawing technique, lead or Tiffany.

Choose the technique and the widths for the project

In the Technical tab, you choose between Lead and Tiffany. This tab also holds the default settings of this project, which you change here without affecting your preferences.

Set the profile widths

In lead: the Width and the Heart of the Type H and Type U profiles. In Tiffany: the Solder line width and the Spacing.

Each path can then be adjusted separately.

Set the cut allowance

In lead, the Cut allowance is the space left between the edge of the glass and the heart of the came. It sets how much each piece is reduced compared to the path of the came in the workshop.

Set the drawing constraints

The Drawing tab holds three settings.

The Min. distance between paths is the distance below which a point placed near a path connects to it automatically. The Shift angle snap is the angle a path snaps to when you hold Shift.

Choose the ends of the cames

Lead came ends chooses whether the came extends past the last point of an open path (Overhang) or stops right there (Flush). An overhanging came can make up for paths that do not touch perfectly.

These three values are pre-filled from your Preferences.

Say where the stained glass will be installed

The Location tab asks for the City or postal code of the installation site. Light mode uses it to place the sun at the real location: its 365 days tab depends on it.

Change the dimensions of a cartoon that is already drawn

Once the project is drawn, Project settings offers the Scale my drawing proportionally checkbox. This checkbox decides what happens to the drawing when you change the dimensions.

If the checkbox is checked, the drawing is enlarged or reduced in the same proportion as the cartoon. If it is unchecked, only the cartoon changes and the drawing keeps its size and position.

Start from an existing project

The Make a copy command duplicates the project in one step, without going through the settings window. The copy keeps the dimensions and all the settings of the original project.

In the editor, Project settings in the project name menu reopens the same window, with the same tabs in the same places. Your changes only take effect when you click Apply: Cancel closes the window without changing anything.

Start for free, with three projects.

Sign up for free

We verify your e-mail address, nothing else.